IS 250 RWD V6-2.5L (4GR-FSE) (2007)
5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
6. REMOVE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)
a. Disconnect all connectors.
b. Remove the 2 nuts and the main body ECU (cowl side junction block LH).
7. REMOVE CLUTCH SWITCH ASSEMBLY
a. Disconnect the connector.
b. Loosen the nut and remove the clutch switch assembly.
INSTALLATION
1. INSTALL CLUTCH SWITCH ASSEMBLY
a. Fully loosen the lock nut of the clutch switch assembly.
b. Adjust the clutch switch until the threaded portion makes gentle contact with the cushion. Tighten the lock nut and verify the contact of the
switch threaded portion with the cushion.