IS 250 RWD V6-2.5L (4GR-FSE) (2007)
3.
Uniformly loosen and remove the 9 camshaft bearing cap M8 bolts in the sequence shown in the illustration.
4.
Remove the 6 camshaft bearing caps.
LH bank:
1.
Check that the camshafts are in the neutral position shown in the illustration.
2.
Uniformly loosen and remove the 8 camshaft bearing cap M6 bolts in the sequence shown in the illustration.
Keep the camshaft horizontal while loosening the bearing cap bolts.
3.
Uniformly loosen and remove the 8 camshaft bearing cap M8 bolts in the sequence shown in the illustration.
4.
Remove the 5 camshaft bearing caps.