IS 250 RWD V6-2.5L (4GR-FSE) (2007)
23.
Remove the cylinder head cover RH.
A.
Remove the 12 bolts, 2 oil seal washers, and cylinder head cover.
^
Cover the hole around the timing chain with shop rags to prevent foreign material from falling into the engine.
^
The baffle plate is located on the back of the portion shown in the illustration.
^
Do NOT damage the baffle plate when removing the cylinder head cover.
B.
Remove the cylinder head cover gasket from the cylinder head cover.
C.
Remove the 3 gaskets.
24.
Remove engine cover No.1 by removing the 3 clips.
25.
Remove the injector driver by removing the bolt and 2 nuts.