IS 250 RWD V6-2.5L (4GR-FSE) (2007)
1. INSTALL MAGNETIC CLUTCH ASSEMBLY
a. Install the magnetic clutch stator with the parts shown in the illustration matched.
b. Using a snap ring expander, install a new snap ring with the chamfered side facing up.
NOTE: Take care not to damage the seal cover of the bearing when installing the snap ring.
c. Connect the connector.
d. Using a snap ring expander, install the magnetic clutch rotor and a new snap ring with the chamfered side facing up.
NOTE:
-
Do not expand the snap ring by more than 35.5 mm (1.39 in.) when installing it.
-
Do not damage the seal cover of the bearing when installing the snap ring.
e. Install the magnetic clutch washer and magnetic clutch hub.
NOTE: Do not change the combination of the magnetic clutch washers used before disassembly.