IS 250 RWD V6-2.5L (4GR-FSE) (2007)
Alignment: Service and Repair
Rear Wheel Alignment
SUSPENSION: REAR WHEEL ALIGNMENT: ADJUSTMENT
ADJUSTMENT
1. INSPECT TIRES
2. MEASURE VEHICLE HEIGHT See: Front Wheel Alignment
3. INSPECT TOE-IN
Toe-in:
If the toe-in is not within the specified range, inspect the suspension parts and replace parts if necessary.
4. ADJUST TOE-IN
(a) Loosen the toe adjust cam nut.
(b) Turn the adjust cams by an equal amount to adjust toe-in.
HINT:
-
Try to adjust the toe-in to the center value.
-
The toe-in will change by the following amount corresponding to each graduation of the cam:
Approx. 4.0 mm (0.16 in.)
(c) Tighten the nut.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
5. INSPECT CAMBER
(a) Install a camber-caster-kingpin gauge or put the wheels on a wheel alignment tester.
(b) Inspect the camber.
CAMBER:
2WD
4WD