IS 250 RWD V6-2.5L (4GR-FSE) (2007)
Standard Resistance
If the resistance value is not as specified, replace the park/neutral position switch assembly.
ADJUSTMENT
1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a) Loosen the bolt of the park/neutral position switch and move the shift lever to the N position.
b) Align the groove and the neutral alignment mark line.
c) Hold the switch in position and tighten the bolt.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
d) After adjustment, perform the inspection.
INSTALLATION
1. INSTALL NEUTRAL START SWITCH ASSEMBLY
a) Install the park/neutral position switch to the manual valve shaft.
b) Temporarily install the bolt.
c) Install anew lock washer and the nut.
Torque: 6.9 Nm (70 kgf-cm, 61 inch lbs.)