IS 250 RWD V6-2.5L (4GR-FSE) (2007)
3. Connect the SST connector to the instrument panel wire assembly.
SST 09082-00700, 09082-00780
NOTE: To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the twin lock.
4. Move the SST at least 10 m (33 ft) away from the vehicle front side window.
5. Maintaining enough clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.
NOTE: Take care not to damage the SST wire harness.
6. Connect the red clip of the SST to the battery positive (+) terminal and the black clip of the SST to the negative (-) terminal.
f.
Deploy the airbag.
1. Check that no one is inside the vehicle or within a 10 m (33 ft) radius of the vehicle.
2. Press the SST activation switch and deploy the airbag.
CAUTION:
-
When deploying the airbag, make sure that no one is near the vehicle.
-
The front passenger airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30
minutes after deployment.
-
Use gloves and safety glasses when handling a front passenger airbag assembly with a deployed airbag.
-
Do not apply water, etc. to a front passenger airbag assembly with a deployed airbag.
-
Always wash your hands with water after completing the operation.
HINT: The airbag is deployed as the LED of the SST activation switch comes on.
2. DISPOSE OF FRONT PASSENGER AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE)
NOTE:
-
When disposing of the front passenger airbag assembly, never use the customer's vehicle to deploy the airbag.
-
Be sure to follow the procedure detailed below when deploying the airbag.
HINT: Prepare a battery as the power source to deploy the airbag.