IS 250 RWD V6-2.5L (4GR-FSE) (2007)
d. Using a moulding remover, disengage the 4 claws and remove the rear seat shoulder belt cover center.
e. Disengage the 3 clips and raise the front portion of the package tray trim panel assembly.
f.
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
g. Disconnect the connector from the center stop light assembly.
h. Disengage the 5 claws and remove the package tray trim panel assembly and the center stop light assembly as a unit.
13. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)
a. Remove the bolt and disconnect the floor end of the rear seat 3 point type belt assembly LH.
HINT: Use the same procedures for the RH side and the LH side.