IS 250 RWD V6-2.5L (4GR-FSE) (2007)
e. Adjust the radar beam axis.
1. Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the
Data Link Connectors 3 (DLC3).
2. Turn the engine switch on (IG).
3. Turn the intelligent tester main switch on, and turn the cruise control main switch on.
4. Select "1: OBD/MOBD".
5. Press the "ENTER" key.
6. Select "8: RADAR CRUISE".
7. Press the "ENTER" key.
8. Select "5: BEAM AXIS ADJUST".
9. Press the "ENTER" key.
HINT:
-
Pressing the "ENTER" key will make the ECM transfer to BEAM AXIS ADJUST MODE.
-
If an error message is displayed on the screen, initialization of the distance control ECU may not be completed. Initialize the distance
control ECU.
-
When the ECM transfers to BEAM AXIS ADJUST MODE, the buzzer sounds for 1 second.