IS 250 RWD V6-2.5L (4GR-FSE) (2007)
Transmission Position Switch/Sensor: Service and Repair
PARK / NEUTRAL POSITION SWITCH
Components
ON-VEHICLE INSPECTION
1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a) Apply the parking brake.
b) Turn the engine switch on (IG).
c) Depress the brake pedal and check that the engine starts when the shift lever is set in the N or P position, but does not start in other positions.
d) Check that the back-up light comes on and the reverse warning buzzer sounds when the shift lever is set in the R position, but the light and
buzzer do not operate in other positions. If a failure is found, check the park/neutral position switch for continuity.
REMOVAL
1. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
2. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a) Disconnect the park/neutral position switch connector.