IS 250 RWD V6-2.5L (4GR-FSE) (2007)
d) Temporarily install the control shaft lever.
e) Turn the control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.
f) Remove the transmission control shaft lever.
g) Align the neutral alignment mark line with the switch groove, and tighten the adjusting bolt.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
h) Using a screwdriver, bend the tabs of the lock washer.