IS 250 RWD V6-2.5L (4GR-FSE) (2007)
/Page-328003.png)
9. REMOVE SIDE AIRBAG SENSOR
a. Remove the nut and side airbag sensor from the body.
b. Disconnect the connector.
INSTALLATION
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. INSTALL SIDE AIRBAG SENSOR
a. Check that the engine switch is off.
b. Check that the battery negative (-) terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
c. Install the side airbag sensor with the nut.
Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)
NOTE:
-
If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a
new one.
-
When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between
other parts.
d. Check that there is no looseness in the installation parts of the side airbag sensor.
e. Connect the connector.
2. INSTALL FRONT SEAT BELT RETRACTOR COVER
