IS 250 RWD V6-2.5L (4GR-FSE) (2007)
a. For an open circuit in the wire harness in Fig. 1, the resistance or voltage as described.
b. Check the resistance.
1. Disconnect connectors A and C and measure the resistance between the terminals of the connectors.
HINT: Measure the resistance while lightly shaking the wire harness vertically and horizontally. If the results match the examples above, an
open circuit exists between terminal 1 of connector A and terminal 1 of connector C.
2. Disconnect connector B and measure the resistance between the terminals of the connectors.
If the results match the examples, an open circuit exists between terminal 1 of connector B2 and terminal 1 of connector C.