IS 250 RWD V6-2.5L (4GR-FSE) (2007)
/Page-1286003.png)
7. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
a. Remove the starter center bearing clutch sub-assembly with the starter drive lever set pin from the starter drive housing.
b. Remove the starter drive lever set pin from the starter center bearing clutch sub-assembly.
REASSEMBLY
1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
a. Apply high-temperature grease to the drive lever set pin, as shown in the illustration.
b. Install the drive lever set pin to the starter center bearing clutch sub-assembly.
c. Install the starter center bearing clutch with the drive lever set pin to the starter drive housing.
