IS 250 RWD V6-2.5L (4GR-FSE) (2007)
/Page-1447002.png)
a) Remove the bolt and engine under cover LH.
4. REMOVE REAR ENGINE UNDER COVER RH
HINT: Remove the RH side following the same procedure as for the LH side.
5. REMOVE FRONT HEIGHT CONTROL SENSOR LINK ASSEMBLY
6. REMOVE FRONT STABILIZER LINK ASSEMBLY LH
a) Remove the 2 nuts and the front stabilizer link assembly LH.
HINT: If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.
7. REMOVE FRONT STABILIZER LINK ASSEMBLY RH
HINT: Remove the RH side following the same procedure as for the LH side.
8. REMOVE FRONT NO.2 STABILIZER BRACKET LH
a) Remove the 2 bolts and the front No.2 stabilizer bracket LH from the front suspension crossmember.
9. REMOVE FRONT NO.2 STABILIZER BRACKET RH
HINT: Remove the RH side following the same procedure as for the LH side.
10. REMOVE FRONT NO.1 STABILIZER BRACKET LH
