IS 250 RWD V6-2.5L (4GR-FSE) (2007)
/Page-1447003.png)
a) Remove the 4 bolts and the front No.1stabilizer bracket LH from the frame.
11. REMOVE FRONT NO.1 STABILIZER BRACKET RH
HINT: Remove the RH side following the same procedure as for the LH side.
12. REMOVE FRONT NO.1 STABILIZER BAR BUSHING
a) Remove the 2 front No.1stabilizer bar bushings from the front stabilizer bar.
13. REMOVE FRONT STABILIZER BAR
a) Remove the front stabilizer bar from the vehicle.
INSPECTION
1. INSPECT FRONT STABILIZER LINK ASSEMBLY
a) Flip the ball joint stud back and forth 5 times as shown in the illustration.
b) Temporarily install the nut, and use a torque wrench to turn the nut continuously at a rate of 2 to 4 seconds per turn. Take the torque reading
on the 5th turn.
Turning torque: 0.05 to 1.96 Nm (0.5 to 20 kgf-cm, 0.4 to 17.3 inch lbs.) or less
c) Check the dust cover for cracks or grease leakage. If the value is not within the specified range, replace the front stabilizer link assembly with a
new one.
INSTALLATION
1. INSTALL FRONT STABILIZER BAR
a) Install the front stabilizer bar to the vehicle.
NOTICE: The identification mark must be on the right side of the vehicle when installing the front stabilizer bar.
2. INSTALL FRONT NO.1 STABILIZER BAR BUSHING
