IS 250 RWD V6-2.5L (4GR-FSE) (2007)
/Page-1447004.png)
a) Install the 2 front No.1 stabilizer bar bushings as shown in the illustration.
NOTICE: Be sure to install the front No.1stabilizer bar bushings so that the cutouts face the front of the vehicle.
3. INSTALL FRONT NO.1 STABILIZER BRACKET LH
a) Press the front No.1stabilizer bracket LH against the frame toward the outside of the vehicle and temporarily tighten bolt A.
b) Install bolt B, fully tighten bolt A, and then install bolts C and D.
c) Install the skid control sensor wire clamp to the front No.1stabilizer bracket LH.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
4. INSTALL FRONT NO.1 STABILIZER BRACKET RH
HINT: Install the RH side following the same procedures as for the LH side.
5. INSTALL FRONT NO.2 STABILIZER BRACKET LH
a) Install the front No.2 stabilizer bracket LH on the vehicle with the 2 bolts.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
6. INSTALL FRONT NO.2 STABILIZER BRACKET RH
HINT: Install the RH side following the same procedure as for the LH side.
7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
