IS 250 RWD V6-2.5L (4GR-FSE) (2007)
a) Temporarily install the rear shock absorber with coil spring with the 2 bolts.
b) Install the 3 nuts on the upper side of the rear shock absorber with coil spring.
Torque: 74 Nm (755 kgf-cm, 55 ft. lbs.)
c) Tighten the 2 bolts.
Torque: 21 Nm (214 kgf-cm, 15 ft. lbs.)
3. TEMPORARILY TIGHTEN REAR NO.2 SUSPENSION ARM
a) Temporarily install the rear No.2 suspension arm with the bolt and nut.
b) Temporarily install the rear shock absorber with rear coil spring with the bolt and nut.
c) Temporarily install the rear stabilizer link assembly and the height control sensor link bracket to the rear No.2 suspension arm with the bolt
and nut.
HINT: Fully tighten the nut after stabilizing the suspension.
4. STABILIZE SUSPENSION
a) Install the rear wheels.
b) Lower the vehicle to the ground. Bounce the vehicle up and down at the corners to stabilize the rear suspension.
c) Remove the rear wheels.