IS 250 RWD V6-2.5L (4GR-FSE) (2007)
c) Remove the 2 screws and shift lock control ECU sub-assembly.
ADJUSTMENT
1. ADJUST SHIFT LEVER POSITION
a) Remove the nut and disconnect the shifting rod.
b) Turn the control shaft lever of the park/neutral position switch counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N
position.
c) Move the shift lever to the N position and tighten the nut while lightly pushing the lever toward the R position.
NOTICE: Do not push the shift lever too hard.
d) After adjustment, check that the shift lever moves smoothly and the shift lever and gear operate correctly
REASSEMBLY
1. INSTALL SHIFT LOCK CONTROL ECU SUB-ASSEMBLY
a) Install the shift lock control ECU sub-assembly with the 2 screws.
2. INSTALL TRANSMISSION CONTROL SWITCH