IS 250 RWD V6-2.5L (4GR-FSE) (2007)
a) Install the thrust cone spring, thrust cone spring plate washer and clutch release hub ball bearing to the clutch release hub as shown in the
illustration.
b) Using a snap ring expander, install the snap ring.
3. INSTALL CLUTCH RELEASE BEARING HUB
a) Fill the groove inside the release bearing hub with grease.
b) Apply grease to the contact surface between the release hub bearing and the clutch cover.
NOTICE:
^
Be sure to apply an even and thin layer of grease.
^
Excessive grease or a lump of grease on the contact surface between the release hub bearing and the clutch cover can splatter and result in
trouble.
c) Using SST, secure the clutch release hub ball bearing.
SST 09950-60020 (09951-00810, 09726-05021)
d) Install the clutch cover assembly, release bearing plate washer and release bearing wave washer.