IS 250 RWD V6-2.5L (4GR-FSE) (2007)
6. INSTALL CLUTCH PEDAL SUB-ASSEMBLY
a) Install the clutch pedal to the clutch pedal support with the pedal shaft, washer, and nut.
Torque: 37 Nm (375 kgf-cm, 27 ft. lbs.)
7. INSTALL CLUTCH PEDAL SPRING HOLDER
a) Apply MP grease to the inside of a new clutch pedal spring holder.
b) Install the clutch pedal spring holder.
8. INSTALL PEDAL WITH HOOK SPRING
a) Apply MP grease to the sliding portion of the spring.
b) Install the hook spring.
9. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS PIN
a) Apply MP grease to the contact surface of the pin and clevis bushing.
b) Connect the clevis to the clutch pedal with the pin.
HINT: Install a pin from the left side of the vehicle.