IS 250 RWD V6-2.5L (4GR-FSE) (2007)
c) Install the new clip to the pin.
10. INSTALL CLUTCH PEDAL SUPPORT SUB-ASSEMBLY
a) Install the clutch pedal support with the 2 nuts and bolt.
Torque: Bolt 24 Nm (242 kgf-cm, 17 ft. lbs.)
Nut 20 Nm (202 kgf-cm, 15 ft. lbs.)
11. CONNECT CLUTCH LINE
a) Using SST, connect the clutch line.
SST 09023-00101
Torque: 15 Nm (153 kgf-cm, 11 ft. lbs.)
HINT: Use a torque wrench with a fulcrum length of 300 mm (11.81 inch).
12. CONNECT CLUTCH RESERVOIR TUBE
a) Connect the clutch reservoir tube.
13. INSTALL WIRE HARNESS