IS 250 RWD V6-2.5L (4GR-FSE) (2007)
/Page-1080007.png)
38. INSTALL REAR AXLE SHAFT NUT
39. STABILIZE SUSPENSION
40. FULLY TIGHTEN NO.1 REAR UPPER CONTROL ARM ASSEMBLY
41. FULLY TIGHTEN NO.1 REAR SUSPENSION ARM ASSEMBLY
42. FULLY TIGHTEN NO.2 REAR SUSPENSION ARM ASSEMBLY
43. INSTALL NO.3 PARKING BRAKE CABLE ASSEMBLY
a) Connect the No.3 parking brake cable assembly to the parking brake equalizer.
b) Install the No.3 parking brake cable assembly to the body with the 3 bolts and 2 clamps.
Torque: Bolt (A) 6.0 Nm (61 kgf-cm, 53 inch lbs.)
Bolt (B) 19 Nm (194 kgf-cm, 14 ft. lbs.)
44. INSTALL REAR SUSPENSION MEMBER BRACE LH
a) Install the rear suspension member brace LH with the 2 bolts.
Torque: 50 Nm (510 kgf-cm, 37 ft. lbs.)
