IS 250C V6-2.5L (4GR-FSE) (2011)
NOTICE:
Remove the bolts while securing the rear suspension member sub-assembly.
(c) Remove the 2 bolts (B), 2 rear lower differential mount stoppers and rear differential carrier assembly with rear drive shaft assemblies.
NOTICE:
*
Do not damage the installation surface when removing the rear differential carrier and rear drive shaft assemblies.
*
Remove the bolts while securing the rear suspension member sub-assembly.
(d) Remove the 2 rear upper differential mount stoppers from the rear differential carrier assembly.
46. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
(a) Support the rear suspension member with a jack using 4 wooden blocks as shown in the illustration.
Text in Illustration
NOTICE:
Make sure to secure the rear suspension member sub-assembly to prevent it from dropping.
HINT
Keep the rear suspension member sub-assembly level.
(b) Remove the 8 bolts, 2 rear suspension member stoppers and rear suspension member lower stoppers from the rear suspension member
sub-assembly.
(c) Slowly lower the rear suspension member sub-assembly.
NOTICE:
When lowering the rear suspension member sub-assembly, be careful not to damage the vehicle body or other components installed on
the vehicle.
47. REMOVE REAR NO. 1 UPPER CONTROL ARM ASSEMBLY (for LH Side)
(a) Remove the bolt, nut, washer, and rear No. 1 upper control arm assembly from the rear suspension member sub-assembly.