IS 250C V6-2.5L (4GR-FSE) (2011)
55. FULLY TIGHTEN REAR NO. 1 UPPER CONTROL ARM ASSEMBLY (for LH Side) See: Steering and Suspension/Suspension/Control
Arm/Service and Repair/Rear Upper Arm/Installation
56. FULLY TIGHTEN REAR NO. 1 UPPER CONTROL ARM ASSEMBLY (for RH Side)
HINT
Perform the same procedure as the LH side.
57. FULLY TIGHTEN REAR NO. 2 UPPER CONTROL ARM ASSEMBLY (for LH Side) See: Steering and Suspension/Suspension/Control
Arm/Service and Repair/Rear Upper Arm/Installation
58. FULLY TIGHTEN REAR NO. 2 UPPER CONTROL ARM ASSEMBLY (for RH Side)
HINT
Perform the same procedure as the LH side.
59. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH See: Steering and Suspension/Suspension/Control Arm/Service and
Repair/Rear Lower Arm/Installation
60. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
61. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH See: Steering and Suspension/Suspension/Control Arm/Service and
Repair/Rear Lower Arm/Installation
62. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
63. INSTALL TAIL EXHAUST PIPE ASSEMBLY (for 2GR-FSE) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
64. INSTALL TAIL EXHAUST PIPE ASSEMBLY (for 4GR-FSE) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
65. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
HINT
Refer to the instructions for Installation of the propeller shaft assembly.
*
for 2GR-FSE: See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and
Repair/Removal and Replacement/Installation
*
for 4GR-FSE: See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and
Repair/Removal and Replacement/Installation
66. INSTALL REAR SUSPENSION MEMBER BRACE LH See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service
and Repair/Rear Shock Absorber/Installation
67. INSTALL REAR SUSPENSION MEMBER BRACE RH
HINT
Perform the same procedure as the LH side.
68. INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR See: Steering and Suspension/Suspension/Suspension Strut / Shock
Absorber/Service and Repair/Rear Shock Absorber/Installation
69. INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR
HINT
Perform the same procedure as the No. 2 differential support protector.
70. ADJUST PARKING BRAKE