IS 250C V6-2.5L (4GR-FSE) (2011)
Yaw Rate Sensor: Service and Repair
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND ACCELERATION SENSOR: INSTALLATION
1. INSTALL YAW RATE AND ACCELERATION SENSOR
(a) Connect the connector.
(b) Install the yaw rate and acceleration sensor with the 2 bolts.
Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)
NOTICE:
*
Do not damage the yaw rate and acceleration sensor.
*
Make sure that the yaw rate and acceleration sensor is installed securely.
(c) Install the 2 wire harness clamps.
2. INSTALL NO. 2 CONSOLE BOX DUCT (for Automatic Transmission) See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
3. INSTALL NO. 2 CONSOLE BOX DUCT (for Manual Transmission) See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
4. INSTALL CONSOLE BOX
HINT
Refer to the instructions for installation of the console box See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal and Replacement/Front Console Box/Installation.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
HINT
See: Testing and Inspection/Programming and Relearning.
7. INSPECT SENSOR SIGNAL
HINT
See: Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure.