IS 250C V6-2.5L (4GR-FSE) (2011)
NOTICE:
Keep the O-rings and O-ring fitting surfaces clean from dirt or any foreign objects.
(d) Install the discharge hose sub-assembly on the cooler condenser assembly with the 2 bolts.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
3. INSTALL LIQUID TUBE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser assembly.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring on the liquid tube sub-assembly.
NOTICE:
Keep the O-rings and O-ring fitting surfaces clean from dirt or any foreign objects.
(d) Install the liquid tube sub-assembly on the cooler condenser assembly with the 2 bolts.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
4. INSTALL UPPER RADIATOR SUPPORT
for 2GR-FSE: See: Engine, Cooling and Exhaust/Cooling System/Radiator/Service and Repair/Installation
for 4GR-FSE: See: Engine, Cooling and Exhaust/Cooling System/Radiator/Service and Repair/Installation
5. INSTALL HOOD LOCK ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release Cable/Service and
Repair/Installation
6. INSTALL HOOD LOCK NUT CAP See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release Cable/Service and
Repair/Installation
7. INSTALL HOOD LOCK CONTROL CABLE COVER See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release Cable/Service
and Repair/Installation
8. INSPECT HOOD SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Hood/Testing and Inspection
9. ADJUST HOOD SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Hood/Adjustments
10. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) See: Accessories and Optional
Equipment/Collision Avoidance and Parking Assist Systems/Distance Sensor/Service and Repair/Installation
11. INSTALL INLET NO. 1 AIR CLEANER
for 2GR-FSE: See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation