IS 250C V6-2.5L (4GR-FSE) (2011)
Brake Light Switch: Service and Repair
Installation
LIGHTING (EXT): STOP LIGHT SWITCH: INSTALLATION
1. INSTALL STOP LIGHT SWITCH ASSEMBLY
(a) Temporarily install the stop light switch assembly with the stop light switch lock nut.
Text in Illustration
(b) Turn the stop light switch assembly so that the clearance between the end of the threaded metal part of the stop light switch and stop light
switch cushion is between 0.5 to 2.4 mm (0.0197 to 0.0945 in.).
Text in Illustration
(c) Tighten the stop light switch lock nut.
Torque : 17 Nm (170 kgf-cm, 12 ft-lbf)
(d) Connect the connector.
2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Knee Airbag Assembly (for Driver Side)/Installation
3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
5. INSTALL INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
6. INSTALL FRONT DOOR OPENING TRIM COVER LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and