IS 250C V6-2.5L (4GR-FSE) (2011)
bolt holding the upper control arm and rear suspension arm so that the values fall within the specified ranges.
7. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
8. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
Disconnect the cable from the negative (-) battery terminal for more than 2 seconds.
NOTICE:
w/ Navigation System for HDD
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
HINT
Perform the yaw rate and acceleration sensor zero point calibration See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Testing and Inspection/Programming and Relearning.
11. CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION
HINT
Check steering angle sensor zero point calibration See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/C Code Charts/C1290.