IS 250C V6-2.5L (4GR-FSE) (2011)
Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench See:
Service Precautions.
3. BLEED BRAKE LINE See: Fluids/Brake Fluid/Service and Repair
4. BLEED BRAKE ACTUATOR
NOTICE:
After bleeding the air from the brake system, if the correct height or feel of the brake pedal cannot be obtained, bleed the air from the
brake actuator assembly with the Techstream by following the procedures below.
(a) Depress the brake pedal more than 20 times with the engine switch off.
(b) Connect the Techstream to the DLC3, then turn the engine switch on (IG).
NOTICE:
Do not start the engine.
(c) Turn the Techstream on and enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Air Bleeding.
(d) Bleed brake actuator following the instructions on the Techstream.
(e) After air bleeding, tighten each bleeder plug.
Torque : 11 Nm (110 kgf-cm, 8 ft-lbf)
(f) Turn the Techstream off and disconnect the Techstream from the DLC3.
(g) Turn the engine switch off.
5. INSPECT FOR BRAKE FLUID LEAK
6. INSPECT FLUID LEVEL IN RESERVOIR See: Fluids/Brake Fluid/Testing and Inspection