IS 250C V6-2.5L (4GR-FSE) (2011)
Drive Belt: Service and Repair
Installation
4GR-FSE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION
1. INSTALL V-RIBBED BELT
(a) Install the V-ribbed belt.
(b) While turning the belt tensioner counterclockwise, remove the 5 mm bi-hexagon wrench.
NOTICE:
*
Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
*
Check that the V-ribbed belt is properly set to each pulley.
(c) If it is difficult to install the V-ribbed belt, perform the following procedure.
Text in Illustration
(1) Put the V-ribbed belt on every part except the tensioner pulley.
(2) Turn the belt tensioner counterclockwise and put the V-ribbed belt on the tensioner pulley.
NOTICE:
*
Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
*
Check that the V-ribbed belt is properly set to each pulley.
2. INSTALL V-BANK COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
3. INSTALL INLET NO. 1 AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
4. INSTALL COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation