IS 250C V6-2.5L (4GR-FSE) (2011)
2. INSTALL ECM COVER
(a) Install the ECM cover with the 3 bolts.
Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)
NOTICE:
Make sure that the wire harness does not get caught between the parts.
3. INSTALL ENGINE ROOM SIDE COVER LH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
4. INSTALL COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning.
7. REMOVE REGISTRATION
NOTICE:
The Vehicle Identification Number (VIN) must be input into the replacement ECM See: Testing and Inspection/Programming and
Relearning