IS 250C V6-2.5L (4GR-FSE) (2011)
/Page-965003.png)
(f) Install a new injector seal to the injector groove (injector tip side) as shown in the illustration.
SST : 09260-39015
09268-03010
09268-03020
(g) Check that the seal covers the circumference of the injector groove as shown in the illustration.
Text in Illustration
SST : 09260-39015
09268-03010
09268-03020
NOTICE:
Make sure that the seal does not slip into the welded groove of the injector shown in the illustration. If it does, replace it with a new
one.
(h) Slowly slide SST (guide) toward the tip of the injector. When the injector contact surface of SST (guide) aligns with the seal (injector
connector side) as shown in the illustration, hold the position for 5 seconds or more to fully align the seal into the injector groove.
Text in Illustration
