IS 250C V6-2.5L (4GR-FSE) (2011)
Fuel Gauge Sender: Service and Repair
Installation
4GR-FSE FUEL: FUEL SENDER GAUGE ASSEMBLY: INSTALLATION
1. INSTALL FUEL SENDER GAUGE ASSEMBLY
(a) Install the fuel sender gauge with the 5 bolts to the fuel tank.
Torque : 1.5 Nm (15 kgf-cm, 13 in-lbf)
(b) Connect the fuel sender gauge connector.
2. INSTALL FUEL SENDER GAUGE
(a) Set the fuel sender gauge to the No. 1 fuel sub-tank. Then slide the sender gauge downward to install it.
Text in Illustration
(b) Connect the fuel sender gauge connector.
3. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE See: Fuel Pump/Service and Repair/Removal and
Replacement/Fuel Pump/Installation
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. INSPECT FOR FUEL LEAK See: Testing and Inspection/Fuel System
6. INSTALL REAR FLOOR SERVICE HOLE COVER
(a) Install the service hole cover with new butyl tape.
7. INSTALL NO. 2 REAR FLOOR SERVICE HOLE COVER See: Fuel Pump/Service and Repair/Removal and Replacement/Fuel
Pump/Installation
8. INSTALL REAR SEAT CUSHION ASSEMBLY RH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat
Assembly/Installation