IS 250C V6-2.5L (4GR-FSE) (2011)
and Repair/Disassembly
5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL See: Body
and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and Repair/Disassembly
6. REMOVE COURTESY LIGHT ASSEMBLY See: Lighting and Horns/Courtesy Lamp/Service and Repair/Vehicle Interior/Door Courtesy
Light/Removal
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Disassembly
8. REMOVE DOOR SIDE AIRBAG SENSOR
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the connector.
NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
(1) While holding the sides of the outer connector locking sleeve, slide the sleeve in the direction indicated by the arrow shown in the
illustration.
Text in Illustration
(2) When the connector lock is released, the connector can be disconnected.
HINT
Be sure to hold both outer flank sides. Holding the top and bottom will make disconnection difficult.
(d) Remove the bolt and door side airbag sensor.
NOTICE:
Loosen the bolt while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.
Installation