IS 250C V6-2.5L (4GR-FSE) (2011)
Telescoping Wheel Switch: Service and Repair
Installation
STEERING COLUMN: TILT AND TELESCOPIC MANUAL SWITCH: INSTALLATION
1. INSTALL TILT AND TELESCOPIC SWITCH
(a) Engage the claw to install the tilt and telescopic switch.
(b) Connect the connector.
2. INSTALL STEERING COLUMN COVER (for Lower Side) See: Steering Column/Service and Repair/Removal and Replacement/Installation
3. ADJUST SPIRAL CABLE See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Installation
4. INSTALL STEERING WHEEL ASSEMBLY See: Steering Wheel/Service and Repair/Installation
5. INSPECT STEERING WHEEL CENTER POINT
6. INSTALL STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Steering
Pad/Installation
7. INSTALL LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Steering Pad/Installation
8. INSTALL LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Steering Pad/Installation
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL See: Steering Column/Service and Repair/Removal and Replacement/Installation
10. INSPECT STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Steering
Pad/Installation
11. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.