IS 250C V6-2.5L (4GR-FSE) (2011)
Torque : 87 Nm (887 kgf-cm, 64 ft-lbf)
(b) Install a new clip to the steering knuckle.
NOTICE:
*
Further tighten the nut up to 60° if the holes for the clip are not aligned.
*
Do not loosen the nut to align the holes for the clip.
4. INSTALL STEERING KNUCKLE WITH AXLE ASSEMBLY
(a) Install the steering knuckle with axle assembly to the front lower ball joint assembly with the 2 bolts.
Torque : 120 Nm (1224 kgf-cm, 89 ft-lbf)
5. INSTALL FRONT DISC
for Floating Type Caliper See: Brakes and Traction Control/Disc Brake System/Service and Repair/Removal and Replacement/Front Brake (for
Floating Type Caliper)/Installation
for Opposed Type Caliper See: Brakes and Traction Control/Disc Brake System/Service and Repair/Removal and Replacement/Front Brake (for
Opposed Type Caliper)/Installation
6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY See: Wheels and Tires/Wheel Fastener/Service and Repair/Front Axle Hub
Bolt/Replacement
7. INSTALL FRONT STABILIZER LINK ASSEMBLY
(a) Install the front stabilizer link assembly with the 2 nuts.
Torque : 84 Nm (857 kgf-cm, 62 ft-lbf)
HINT
If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.
8. CONNECT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY (w/ HID Headlight System)
(a) Connect the height control sensor link sub-assembly with the nut.