IS 250C V6-2.5L (4GR-FSE) (2011)
(b) Connect the 2 switch wire connectors to the shift paddle switches.
Text in Illustration
(c) Install the connector to the steering wheel assembly.
(d) Install the clamp to the steering wheel assembly.
2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
3. ADJUST SPIRAL CABLE See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Installation
4. INSTALL STEERING WHEEL ASSEMBLY See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Installation
5. INSTALL STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Steering
Pad/Installation
6. INSTALL LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Steering Pad/Installation
7. INSTALL LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Steering Pad/Installation
8. INSPECT STEERING WHEEL CENTER POINT
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
*
Make sure that the cable has been disconnected from the battery terminal for at least 2 seconds before reconnecting the cable.
*
Connect the cable to the negative (-) battery terminal with the front wheels facing straight ahead.
10. INSPECT STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Steering
Pad/Installation
11. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.