IS 250C V6-2.5L (4GR-FSE) (2011)
Clutch Master Cylinder: Service and Repair
Installation
CLUTCH: CLUTCH MASTER CYLINDER: INSTALLATION
1. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY
(a) Install the clutch master cylinder assembly with the 2 bolts.
Torque : 12 Nm (120 kgf-cm, 9 ft-lbf)
(b) Connect the clutch reservoir tube.
2. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS PIN
(a) Apply MP grease to the contact surfaces of the pin and a clevis bushing.
Text in Illustration
(b) Connect the clevis to the clutch pedal with the pin.
HINT
Install the pin from the left side of the vehicle.
(c) Install a new clip to the pin.
3. INSTALL CLUTCH PEDAL SWITCH ASSEMBLY
(a) Install the clutch pedal switch assembly with the nut.
Torque : 16 Nm (160 kgf-cm, 12 ft-lbf)
4. INSTALL CLUTCH PEDAL SUPPORT SUB-ASSEMBLY See: Clutch Pedal Assembly/Service and Repair/Installation
5. CONNECT CLUTCH LINE
(a) Using a union nut wrench (10 mm), connect the clutch line.
Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)