IS 250C V6-2.5L (4GR-FSE) (2011)
NOTICE:
Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench See:
Service Precautions.
6. CONNECT CLUTCH RESERVOIR TUBE See: Clutch Pedal Assembly/Service and Repair/Installation
7. INSTALL WIRE HARNESS
(a) Connect the 3 connectors and clamp.
8. FILL RESERVOIR WITH BRAKE FLUID See: Brakes and Traction Control/Hydraulic System/Brake Fluid/Service and Repair
9. BLEED CLUTCH LINE See: Service and Repair/Procedures
10. INSPECT FLUID LEVEL IN RESERVOIR See: Brakes and Traction Control/Hydraulic System/Brake Fluid/Testing and Inspection
11. INSPECT FOR FLUID LEAK
HINT
Check for leaks from the clutch system.
12. INSPECT AND ADJUST CLUTCH PEDAL HEIGHT
See: Clutch Pedal Assembly/Adjustments
13. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Knee Airbag Assembly (for Driver
Side)/Installation
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
15. INSPECT SRS WARNING LIGHT
See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System