IS 250C V6-2.5L (4GR-FSE) (2011)
Differential Mount: Service and Repair
Installation
AXLE AND DIFFERENTIAL: DIFFERENTIAL MOUNT CUSHION: INSTALLATION
1. INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION
(a) Using SST, install a new rear No. 1 differential mount cushion.
Text in Illustration
SST : 09316-12010
SST : 09570-24011
NOTICE:
*
Make sure that the differential mount cushion is aligned within 3° from the center.
*
Be sure to use the correct combination of SST.
*
Before using SST, apply grease to SST bolts.
*
Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it
from tilting and install SST.
*
Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.
*
Do not slant the bolts of SST.
*
Tighten the 2 bolts of SST equally into the 2 holes of the rear No. 1 differential mount cushion.
2. INSTALL REAR NO. 2 DIFFERENTIAL MOUNT CUSHION
(a) Using SST, install a new rear No. 2 differential mount cushion.