IS 250C V6-2.5L (4GR-FSE) (2011)
Text in Illustration
(g) Check that the center line of the bracket is perpendicular to the shaft axial direction.
(h) Tighten the 2 bolts.
Torque : 49 Nm (500 kgf-cm, 36 ft-lbf)
2. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for Manual Transmission)
(a) Remove SST from the transmission.
SST : 09325-20010
(b) Insert the yoke of the intermediate shaft into the transmission.
NOTICE:
Be careful not to damage the oil seal.
(c) Install the 2 center support bearing washers, center support bearing and 2 center support bearing dampers.