IS 250C V6-2.5L (4GR-FSE) (2011)
4. SET SLIDE ROOF MOTOR ASSEMBLY
(a) Manually move the slide roof motor assembly to the position shown in the illustration.
5. TEMPORARILY TIGHTEN UPPER BACK WINDOW FRAME SUB-ASSEMBLY See: Body and Frame/Roof and Associated
Components/Convertible Top/Service and Repair/Removal and Replacement/Installation
6. SET UPPER BACK WINDOW FRAME SUB-ASSEMBLY
(a) Manually close the upper back window frame sub-assembly.
NOTICE:
*
Perform this operation using 2 persons.
*
Synchronize the movement of the left and right sides of the upper back window frame sub-assembly when moving it.
(b) Using a screwdriver, disengage the claw and remove the lock cover (for rear side).
(c) Insert a 5 mm hexagon wrench into the sliding roof drive gear shaft (lock motor shaft) through the hole in the roof headlining.
(d) Using a 5 mm hexagon wrench, turn the sliding roof drive gear sub-assembly clockwise to engage the lock of the rear slide roof panel
sub-assembly.