IS 250C V6-2.5L (4GR-FSE) (2011)
8. FULLY TIGHTEN UPPER BACK WINDOW FRAME SUB-ASSEMBLY See: Body and Frame/Roof and Associated Components/Convertible
Top/Service and Repair/Removal and Replacement/Installation
9. FULLY TIGHTEN SLIDE ROOF MOTOR ASSEMBLY (for LH Side) See: Body and Frame/Roof and Associated Components/Convertible
Top/Service and Repair/Removal and Replacement/Installation
10. SET UPPER BACK WINDOW FRAME SUB-ASSEMBLY
(a) Using a 5 mm hexagon wrench, turn the sliding roof drive gear sub-assembly counterclockwise to release the lock of the rear slide roof panel
sub-assembly.
NOTICE:
*
Insert the hexagon wrench all the way in and turn it with both hands.
*
Do not apply excessive force after the drive gear stops turning.
HINT
The locks will release when the wrench is turned approximately 360 degrees.
(b) Install the lock cover (for rear side).
Text in Illustration
(c) Manually move the upper back window frame sub-assembly to the position shown in the illustration.
NOTICE:
*
Perform this operation using 2 persons.
*
Synchronize the movement of the left and right sides of the upper back window frame sub-assembly when moving it.
11. INSTALL ROOF SIDE INNER GARNISH LH See: Window Glass/Back Window Glass/Service and Repair/Installation