IS 350 V6-3.5L (2GR-FSE) (2006)
D.
Hold the No.2 chain and install the No. 3 chain tensioner assembly.
Torque: 21 N.m (214 kgf.cm, 15 ft.lbf)
4.
Install the No. 2 camshaft using the same procedure as step 38.
5.
Install the camshaft bearing cap.
A.
LH bank:
(1)
Clean the camshaft bearing caps and apply engine oil.
(2)
Make sure that the valve rocker arms are properly installed with each lash adjuster and valve stem cap.
(3)
Make sure of the marks and numbers on the camshaft bearing caps and temporarily tighten the 16 bolts.
(4)
Tighten the 8 M6 bolts in the sequence shown.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)