IS 350 V6-3.5L (2GR-FSE) (2006)
a. While releasing the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.
b. While turning the belt tensioner counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the
belt tensioner.
INSTALLATION
1. INSTALL V-RIBBED BELT
a. Install the V-ribbed belt.
b. While turning the belt tensioner counterclockwise, remove the bar.
NOTICE:
^
Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
^
Check that the V-ribbed belt is properly set to each pulley.
c. If it is difficult to install the V-ribbed belt, perform the following procedure.
1. Put the V-ribbed belt on every part except the tensioner pulley as shown in the illustration.
2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.