IS 350 V6-3.5L (2GR-FSE) (2006)
/Page-1651002.png)
b. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
NOTE: When removing the steering pad, do not pull the airbag wire harness.
c. Disconnect the horn connector.
d. Disconnect the 2 connectors from the steering pad.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
e. Remove the steering pad.
INSTALLATION
1. INSTALL STEERING PAD
a. Support the steering pad with one hand as shown in the illustration.
b. Connect the 2 connectors to the steering pad.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
c. Connect the horn connector.
d. Confirm that the circumference groove of the "torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
e. Using a "torx" socket wrench (T30), tighten the 2 "torx" screws.
Torque: 8.8 N.m (90 kgf.cm, 78 in.lbf)
