IS 350 V6-3.5L (2GR-FSE) (2006)
/Page-1651039.png)
a. Check the function of the SST.
b. Remove the front seat airbag assembly.
1. Remove the front seat assembly.
2. Remove the front seat assembly.
3. Remove the 2 nuts and the front seat airbag assembly from the seatback assembly.
CAUTION:
-
When removing the front seat airbag assembly, work must be started 90 seconds after the engine switch is turned off and the negative
(-) terminal cable is disconnected from the battery.
-
When storing the front seat airbag assembly, keep the airbag deployment side facing upward.
4. Remove the 2 nuts and the front seat airbag assembly from the seatback assembly.
CAUTION:
-
When removing the front seat airbag assembly, work must be started 90 seconds after the engine switch is turned off and the negative
(-) terminal cable is disconnected from the battery.
-
When storing the front seat airbag assembly, keep the airbag deployment side facing upward.
c. Using a service-purpose wire harness for the vehicle, tie down the front seat airbag assembly to the tire.
Wire harness:
Stripped wire harness section 1.25 mm2 or more (0.0019 in.2 or more)
HINT: To calculate the area of the stripped wire harness section: Area = 3.14 x (Diameter)2 divided by 4
CAUTION: If the wire harness is too thin or an alternative object is used to tie down the front seat airbag assembly, it may be snapped by the
shock when the airbag is deployed. Always use a wire harness for vehicle use with an area of at least 1.25 mm2 (0.0019 in. 2).
1. Install the 2 nuts to the front seat airbag assembly.
