IS 350 V6-3.5L (2GR-FSE) (2006)
b. Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner
connector as shown in the illustration.
HINT: Tape the screwdriver tip before use.
c. Disconnect the connectors.
d. Remove the 2 bolts and the front seat outer belt assembly.
INSTALLATION
1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
a. Check the degree of tilt when the ELR begins to lock.
1. Check that the belt does not lock at less than 15 degreesof tilt in any direction but locks at over 45 degrees of tilt while gently pulling the
belt.
NOTE: Do not disassemble the retractor.