IS 350 V6-3.5L (2GR-FSE) (2006)
11. REMOVE ROOF SIDE INNER GARNISH RH
12. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (W/o Rear Sunshade)
13. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (W/ Rear Sunshade)
14. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY
a. Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner
connector as shown in the illustration.
b. Remove the 2 bolts and the rear seat 3 point type belt assembly.
INSTALLATION
1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY
a. Check the degree of the tilt when the ELR begins to lock.
1. Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the
belt.
NOTE: Do not disassemble the retractor.